Prepare: Clean the headlight lens with water. Mask off the surrounding perimeter of the lens to avoid scratching the paint of the vehicle.

Step1. Sand

Wet the sanding disc and attach it to the backer pad. Sand with three different grits to completely remove the heavy yellowing, fading, and corrosion.

Note: Use the sanding discs from coarse to fine: P800--> P1200--P2000. Not doing so will result in restoration failure

Step2. Polish

Attach. the orange sponge disc to the backer pad and apply the polish paste. Polish the lens until the shine is restored to its original condition.

Note: For best results, use an electric buffer or polisher. If polishing by hand, polish with no less than 200 strokes in a circular, clockwise motion.

Step3.UV Protection Liquid (Important)

Clean the headlight lens and make sure the lens is dry before the protection step. Use the white sponge disc provided in the kit. Apply the protective liquid on the surface of the lens. After applying it, stay for 10-15 minutes to let the liquid flow evenly itself. Then dry it in direct sunlight immediately (1 to 2 hours is suggested). if not, dust and other dirt will adhere to protect the liquid due to its viscosity, which will affect the brightness of the headlight.                                 

Note: Please avoid any sunlight when applying the protective liquid on the headlight (very important). After step 3, keep the lens dry. Do not wash the car for 24 hours

Step4. About removing the Masking Tape

After finishing all the steps, please remove the masking tape, otherwise the longer the time, the harder it is to remove, and may leave traces